Bubble recycled broken fuse machine is a kind of environmental protection and resource recycling equipment, used for processing appliances packaging EPS foam extrusion directly after crushing, to make it into a small c block, is helpful to transport This machine has high social benefits and economic benefits
Main technical parameters

Main motor power: 15kW
Reducer ratio: 1: 9.9
Heating power: 2.6kW
Screw speed: 200rpm
Screw diameter: φ 145mm
Rotary knife speed: 100rpm
Rotary knife quantity: 7
Fixed blades quantity: 6
Production capacity: 120kg/h
Dimension: (L× W× H) 1200× 1200× 1200 (mm)
Installation and Debugging

Test should be performed by the personnel familiar with the machine and process, and record the situation analysis for trial run before, first check the electrical system, then check that the drive system and operating parts shall be safe and reliable.

The machine at the bottom of the stand, there are four castor, any move to the desired location, after installed, adjust the bottom four fixed screw, the machine does not produce displacement.

Connected to the three-phase 380V, 60HZ power to the circuit breaker QF1, closed circuit breaker QF1, QF2, QF3; Press SB2 (start) button, (SB1 as the stop button) to check the direction of the spindle is consistent with the direction of the arrow, if inconsistent, replace the power line in any two. Open the knob SA2, BT1 temperature table adjustment the heating temperature of the heater according to a preset temperature automatically heating, KM2 job. When heated actual temperature exceeds the preset temperature(adjustable), start the alarm buzzer HA.
3\, , , HA.
The motor is running, if there is too much or because of feeding debris into, the main motor overload protection, alarm buzzer HA start.

If an emergency occurs during use, press the emergency stop button SA1, the machine stopped working.

According to process requirements, adjust the temperature controller setpoint temperature, when the temperature reaches the set value, and then incubated for one hour, then feed production. In the production period of time, to turn off the heating power, the heat by the friction between the screw and barrel generated by the formation of C blocks.

Under normal circumstances, without cleaning the barrel after the shutdown memory material, but before the next boot, the barrel is necessary to fully preheat and heat, can be added if necessary to keep a small amount of raw material to open low-speed extrusion.